How to push a configuration out to endpoints

Are you having trouble pushing a configuration out to your endpoints? Don't worry, Vyopta has you covered! This article will provide you with step-by-step instructions on how to force a scan on your endpoint and push a configuration.

The collector will set the parameters for an endpoint when it first scans the endpoint. Therefore, the way to force this is to force an initial scan to take place. This can be achieved by doing one of the following:

  • Remove the endpoint from the access group and save the changes. Wait for 5 minutes and re-add the endpoint to the access group.
  • If you have many endpoints to set, remove the monitoring group from the user, save the changes. Wait for 5 minutes and re-add the user back to the monitoring group.

These steps will help you force a scan on the endpoint and this push this configuration. For more information on how to configure your endpoints, please refer to our Knowledge Base article.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.